Pro Engineer Installation Steps

For Pro E installation follow the following steps

1.  Start pro/e setup
2.  Open license.dat with any  txt-editor and replace every occurance of 00-00-00-00-00-00 with your computer real HOST_D (same one shown in the bottom left corner of the Pro/e setup). Save the license.dat
3. Save that edited license.dat file , don't replace, remove or delete that file.
4.   Install proe - proe_mech -ptc_distributed_services (optional). On license-config screen select "nodelocked license" and point to edited license.dat

Next  apply a patches (if u didn't install the complete package, you will get "File not found" errors, accept or bleed)

• For pro/engineer:

Copy "proe_WF5_Win64_crk.exe" to folder <proeWildfire 5.0 progdir>\x86e_win64\obj and click "Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"

• For pro/mechanica

Copy "proe_mech_WF5_Win64_#1_crk.exe" to folder <proeWildfire 5.0 progdir>\x86e_win64\obj and click "Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"
Copy "proe_mech_WF5_Win64_#2_crk.exe" to folder <proe mech WF5 progdir>\x86e_win64\ptc and click "Start > OK"

• For ptc distributed services

Copy "ptc_distributed_services_WF5_Win64_crk.exe" to folder <ptc_distributed_services WF5 Win64 progdir>\x86e_win64\obj and click "Next > OK > Finish > OK"

Read More